Prime Auto: Cameron’s LS1 Fc
This past weekend Cameron brought out his new toy, recently trading it for his Rb25 240sx. Me being a Mazda fiend I think he got the greater end of the deal by a mile! The FC is one of the best chassis for any type of Motorsport activities from road racing to Cone dodging in the parking lot. This car started its life as a S4 GXL, but was swapped over to everything S5 and equipped with Shine Auto Project pieces. The LS1 power plant was reworked in and out to extend the already reliable LS1, and puts down 383hp at the wheels. Cameron has not had a chance to put his own touches on the car as of yet, but he has plans to change the wheels, new exhaust, and upgraded heads.
Timeless coupe design!
The best bang for the buck the LS1 swap, there is a reason why everyone does it…
Not just a pretty face, Cam out there testing the new toy!
1987 GXL rx7
Engine/Trans
99 ls1
t56 4k on rebuild and Southbend clutch
Fully rebuilt with new syncro assemblies and slider hubs
brass shifter pads for all 3 forks
steel 3-4 shift fork
billet keys and springs for all 3 assemblies
new bearings and seals
new snap rings
new stock flywheel
Torquer 2 Cam
241 casting heads
patriot performance dual valve springs
titanium retainers
chormolly pushrods 7.400
ls7 lifters
ported ls6 oil pump
ls2 Timing chain
ls6 intake
South Bend XD Clutch
ported throttle body
long tube 1 3/4 Headers
Walboro 255lph fuel pump
2.5in exhaust with x pipe
magnaflow mufflers
T2 rear diff, axles,and steel T2 hood
solid dif mount
Grannys radiator and custom Bracket
c4 Aluminnum corvette driveshaft
Hinson Supercars Steel braided clutch line kit
6an steel braided fuel lines feed and return Mallory fuel pressure regulator and guage.
skip shift eliminator
K&N cool air intake
Mustang dyno numbers
383 RWHP
363 RWTQ
Exterior:
Full s5 Conversion
Shine Auto Project Front lip/roof wing/valances/sideskirts
MMR solid dif mounts and subframe mounts
MMR Spherical Rear Control Arm Bearings
18×8.5+30 and 18×9.5 +35 offset 5zigen fn01rc in Bronze
275/35 rear 225/40 front Toyo Proxes
Sparco Rev Drivers seat with RJS 5pt. harness
Stock S5 passenger seat
Suede Headliner, door inserts and arm rest
6 pt roll cage
SUSPENSION/BRAKES
wilwood 1″ master cylinder
steel braded Brake lines
energy suspension full ployurathane kit
Front strut bar
DTSS eliminators
Ksport coilovers
AWR camber ajusters
Racing beat Front and rear swaybars
Hptuners Tuned by Rob Raymer in louisville KN
good stuff!